typical GC20606-D2 - Page 45

1. Brief introduction..........................................................................................1
2. Main specifications........................................................................................1
3. Installation and preparation.........................................................................1-4
4. Operation...................................................................................................4-8
5.Machine adsjustment..................................................................................5-13
1. Arm parts...............................................................................................14-17
2. Upper shaft and presser foot parts............................................................18-19
3. Needle bar and lower feed parts................................................................20-23
4. Lower shaft and thread looping parts.........................................................24-25
5. Automatic reverse feed and testing parts....................................................26-29
6. Thread releasing and auto-trimming parts..................................................30-33
7. Knee control presser foot lift parts............................................................34-35
8. Winding componcnt
(GC20606L18-D2T/-1L18-D2T/HL18-D2T/-1HL8-D2T).........................36-37
9.Lubrication parts.....................................................................................38-39
10.Foot lifter part
(GC20606L18-D2T/-1L18-D2T/HL18-D2T/-1HL8-D2T)..............................40
11. Accessory.............................................................................................41-42
.
.
Content
Operation Instruction
Parts Manual