8 // CLEANING AND MAINTENANCE
8/2 Lubricating
Use only grease which is recommended by TYPICAL.
1. Switch machine off on the main switch.
2. Remove the screws which are marked with arrows.
3. Grease the marked spots until grease is coming
out slightly.
4. Tighten screws and set screws to push the
grease into the openings.
5. Turn the hand wheel a few times in order to spread the
grease with the needle bar.
6. Wipe excess grease with a cloth around the screws and
set screws, below the needle bar and the lower part of
needle bar frame clean.
To Next Page
Loading...
