U-Line BCM-95 User Manual

02/2005 3 www.U-LineService.com
WH95TP, BI95BTP and BCM95 Ice Makers
General Precautions
Use this appliance for its intended purpose only and
follow these general precautions along with those listed
throughout this guide:
WARNING
SHOCK HAZARD — Electrical Grounding Required.
• Keep the unit unplugged throughout installation
except during testing.
• Never remove the round grounding prong from
the plug and never use a two-prong grounding
adapter.
• Never use an extension cord to connect power to
the unit.
• Always keep your working area dry.
CAUTION
• Use care when moving and handling the unit. Use
gloves to prevent personal injury from sharp edges.
• Do not lift the unit by the door or door handle.
• Do not install the unit behind closed doors or in any
way that would obstruct airflow to the front grille,
which may cause the unit to malfunction.
You have received a carton containing your WH95TP,
BI95BTP or BCM95 Ice Maker with a package inside
containing a User Manual, a Product Registration Card
and water connection parts. Complete and mail the
Product Registration Card or register online at www.U-
LineService.com. Once your unit is installed, keep the User
Manual and this Installation Guide in a safe place for
future reference.
WH95TP units are available in vinyl clad cabinets with
matching doors which have a metal door frame and
handle, a travel pin to secure closure and are reversible.
1/4-inch thick panel not available for this model.
BI95BTP units are available in vinyl clad cabinets with
matching doors which have a slightly contoured handle
across the top, a travel pin to secure closure and are
reversible. The doors have recessed front panels that will
accept a custom 1/4-inch thick door panel.
BCM95 units are available in vinyl clad cabinets with doors
that have a black glass panel, a handle across the top, a
travel pin to secure closure and are reversible. 1/4-inch
thick panel not available for this model.
Please carefully follow the directions that apply to your
unit and your intended design.
Tools/Materials Required
• Screwdrivers — slotted and Phillips head
• 1/4-inch OD copper tubing and shut-off valve for water
supply line
• 1/4-inch thick door panel material and cutting tools
(item only needed if 1/4-inch panel will be used)
Inspection
Unwrap and inspect the unit on a flat, level surface
capable of supporting its entire weight.
Exterior Cleaning
(As Required)
Black and White Models:
Black and white surfaces may be cleaned with a mild
detergent and warm water solution. Do not use solvent-
based or abrasive cleaners. Use a soft sponge and rinse
with clean water. Wipe with a soft, clean towel to prevent
water spotting.
2 Inspect and Plan

U-Line BCM-95 Specifications

General

Brand	U-Line
Model	BCM-95
Category	Ice Maker
Language	English