To Next PageTo Next Page
Need help?Do you have a question about the U-Line Better Pack 555eS and is the answer not in the manual?
General| Voltage | 115V |
|---|---|
| Type | Electric Tape Dispenser |
| Tape Width | 1" - 3" (25 mm - 76 mm) |
| Tape Length | 6 to 45 inches |
| Dispensing Speed | 45 inches per second |
| Dimensions | 20.5 x 12.5 x 12 inches |
Check the machine for damage upon unpacking. Return if damaged.
Details machine dimensions, weight, power, speed, tape types, width, and roll diameter.
Detailed steps for removing the dispenser from packaging.
Lists items included with the tape dispenser.
How to adjust roll guides for different tape widths.
Fine-tuning roll guide spacing and centering for tape.
Step-by-step guide on how to properly load tape into the dispenser.
Ensures the upper tape plate is correctly seated around the drive wheel.
Guide for installing the water tank and bottle components.
Connecting the power cord to the dispenser and power supply.
Details on connecting the power cord and electrical panel components.
Steps to power on the dispenser and initial indicators.
How to set the heater temperature for optimal tape adhesion.
Differences between automatic and standard models.
How to select tape lengths using the keypad on the H-800.
How to select tape lengths using the keypad on the H-1037.
How to dispense tape of arbitrary or specific lengths.
Modifying standard lengths and doubling them using keypad buttons.
How to re-dispense the last used tape length.
How the dispenser automatically dispenses tape in automatic mode.
Sequentially dispensing multiple pre-set tape lengths.
Guidance on adjusting heat settings for optimal adhesive performance.
Recommendations for determining the appropriate tape length for sealing cartons.
Best practices for applying gummed tape to cartons for a strong bond.
Weekly cleaning of components for proper tape adhesion.
Removing adhesive buildup from shear blades using a brush and naphtha.
Step-by-step instructions for removing jammed tape from the dispenser.
Procedure for checking and replacing a blown fuse.
Maintaining the blade oiler with light machine oil.
Instructions for brushing out paper dust and avoiding spray cleaners.
Key technical details including tape width, speed, capacity, and power requirements.
Details on I/O ports for optional devices and connector types.
