PAGE 12 OF 36 0521 IH-800
CLEANING
Inside this dispenser:
• Brush out paper dust.
• Do not use spray cleaners
Exterior surface of the dispenser:
• Brush out paper dust.
• Do not use spray cleaners
MAINTENANCE CONTINUED
TECHNICAL SPECIFICATIONS
CHARACTERISTIC MEASUREMENT
Tape Width 1.5-3"
Maximum Tape Roller Diameter 10"
Tape Lengths Dispensed Short Models (auto & std.) 6-45"
Long Models (auto & std.) 12-90"
Dispenser Speed 45 inches per second
Number of Brushes 3
Water Bottle Capacity 34 oz.
Shipping Weight 32 lbs.
Dimensions (L x W x H) 20 x 12.5 x 12"
Power Requirements
555eS, eSA, eL, eLA
555eM, eMA
555eL, eJA
115v 60Hz, 4 Amps
230v 50/60Hz, 2 Amps
100v 50/60Hz, 4 Amps
PORT CONNECTIVITY
The 9-pin female connector at the rear of the dispenser
is Input/Output (I/O) allowing communication with
optional devices such as the AMD-1, an Automatic
Carton Measuring Device.
• On standard models, this I/O port is active for use
with pedal foot switches or other similar devices
which use the "contact closure" method of sending
a signal.
• On automatic models, this I/O also provides access
to the dispenser's RS-232C serial data port. Pedal
foot switches or other "contact closure" devices may
still be used on automatic models.
CONNECTOR CONFIGURATIONS
Both standard and automatic models are equipped
with 9-pin female D-type connectors.
-800-295-551
To Next Page
Loading...
