PAGE 2 OF 9 0921 IH-5052
ASSEMBLY CONTINUED
Figure 2
Figure 3
Figure 4
2. Align armrest with holes on bottom of seat cushion. Use
two 5/16 x 1¼" screws (1) and two 5/16" x 1½" screws (4)
to attach. Repeat on opposite side.
(See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
3. Align mechanism with holes on bottom of seat cushion.
Use four 5/16 x 1" screws (2) and Allen wrench to attach.
(See Figure 3)
4. Align back cushion mounting plate with holes on
bottom of seat cushion. Use two 3/8 x 1⁄" screws
(3) and two 3/8 x 1¼" screws (5) and Allen wrench to
attach. (See Figure 4)
4
1
2
5
3
To Next Page
Loading...
