U-Line H-10304 User Manual

PAGE 1 OF 9 1222 IH-10304
1-800-295-5510
uline.com
H-10304
STAINLESS STEEL SINK
PARTS
ASSEMBLY
1. Affix corner and end castings to crossbracing.
Secure crossbracing to castings with set screws
using 5/32" Allen wrench. (See Figure 1)
NOTE: Use care not to over-tighten screws or
failure may occur.
Figure 1
Corner
Castings
End Castings
Crossbracing
Sink x 1
End Casting x 2 Set Screw x 18
Corner Casting x 2
Legs with
Adjustable Feet x 4
Crossbracing x 3
5/32" Allen Wrench
(included)
TOOL NEEDED
Drain Basket Kit
Drain Basket x 1 Drain Basket
Lock Ring x 1
Drain Basket
Rubber Gasket x 1
Drain Basket
Paper Gasket x 1
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.

U-Line H-10304 Specifications

General

Brand	U-Line
Model	H-10304
Category	Indoor Furnishing
Language	English

Summary

Tool Needed for Assembly

5/32" Allen Wrench

Specifies the required 5/32" Allen wrench for assembly, noting it is included.

Sink Frame Assembly

Attach Castings to Crossbracing

Connect corner and end castings to the crossbracing using set screws and the 5/32" Allen wrench.

Position Legs and Crossbrace

Push legs through casting collars to desired height, marking for exact measurement to meet NSF standards.

Secure Legs to Crossbrace

Secure legs to the crossbrace using set screws with the 5/32" Allen wrench.

Mount Sink onto Legs

Stand sink upright, place onto legs, and tighten set screws on each gusset with the Allen wrench.

Level Sink with Adjustable Feet

Level the sink using the adjustable feet, which allow approximately 1" of adjustment.

Drain Assembly

Install Drain Basket

Install drain basket into sink hole, securing with gaskets and lock ring from underneath.