PAGE 2 OF 9 1222 IH-10304
ASSEMBLY CONTINUED
2. With crossbrace on its side, push legs through the
casting collars to the desired height. To ensure exact
height, mark desired height on each leg with magic
marker or grease pencil. (See Figure 2)
NOTE: Each leg must be at the same height or
casting collars could fail. Height from the floor to
the top of the crossbracing must be 6" or higher
to meet NSF standards.
3. Secure legs to crossbrace with set screws using 5/32"
Allen wrench. (See Figure 3)
4. Stand sink upright and place onto legs, inserting
legs into the gussets. With a 5/32" Allen wrench,
tighten set screw on each gusset. (See Figure 4)
5. Level sink with the adjustable feet. Adjustable feet
allow approximately 1" of adjustment. (See Figure 5)
Figure 4
Figure 5
Figure 3
Figure 2
To Next Page
Loading...
