Ubee UBC1329AA00 User Manual

Ubee UBC1329AA00 Advanced Wi-Fi 6 Voice Gateway User Manual • February 2021 44
Channel
Bandwidth
The 802.11n specification provides a 40MHz-wide channel in addition to the legacy 20MHz-
wide channel available with older wireless specifications. Options for the 2.4GHz network
are:
 20: Set to 20 to restrict use to a 20MHz channel only.
 20/40: Set to 20/40 to enable use of the 40MHz channel. Note that this enables higher
data rates, but only clients supporting 802.11n/ac may connect.
 Auto: Selecting Auto will let the UBC1329AA00 select the proper channel width based
on local usage, interference and traffic. It selects the channel on boot-up, and does not
change until a reboot/power cycle of the device.
Network
Password
Show
Network
Password
The current wireless network password is displayed here. Click the Show Network Password
box to be able to read the password, otherwise it is displayed in dots.
Changing the Wireless Password:
You can change the wireless password to a personalized one.
1. Highlight the old password and delete it.
2. Check the Show Network Password box to be able to read the password.
3. Enter your personalized network password and then click Save Settings at the bottom of
the page.
Broadcast
Network
Name
When enabled, the SSID, or network name, is visible to wireless clients wishing to connect to
the UBC1329AA00. When not enabled, the SSID will not
be visible for connection.
Enable
WMM
Check the box to enable WMM (Wi-Fi Multimedia). WMM controls WLAN transmission
priority on packets transmitted over the wireless network to ensure quality of serive in your
wireless network.
NOTE: Disabling WMM will break the 802.11n specification and result in speeds that tend
toward a maximum speed of 54Mbps (802.11g max speeds).
Save
Settings
Select to save the 2.4GHz wireless configuration.
Cancel Select to cancel the 2.4GHz wireless configuration.
Label Description

Ubee UBC1329AA00 Specifications

General

Brand	Ubee
Model	UBC1329AA00
Category	Gateway
Language	English