Ubee UBC1329AA00 Advanced Wi-Fi 6 Voice Gateway User Manual • February 2021 48
Channel
When Manual channel selection is chosen, you are able to select your preferred channel
from the drop down menu. Options for the 5GHz network are: 36, 40, 44, 48, 149, 153, 157,
161 and 165.
Channel
Bandwidth
The 802.11n and 802.11ac specifications provide a 40MHz-wide channel in addition to the
legacy 20MHz-wide channel available with older wireless specifications. 802.11ac and
802.11ax specifications allow an 80MHz-wide channel.
Options for the 5GHz network are:
20: Set to 20 to restrict use to a 20MHz channel only.
20/40: Set to 20/40 to enable use of the 40MHz channel. Note that this enables higher
data rates, but only clients supporting 802.11n/ac may connect.
20/40/80: Set to 20/40/80 to use an 80MHz-wide band. Only clients supporting
802.11ac/ax may connect.
Auto: Selecting Auto will let the UBC1329AA00 select the proper channel width based
on local usage, interference and traffic. It selects the channel on boot-up, and does not
change until a reboot/power cycle of the device.
Network
Password
Show
Network
Password
The current wireless network password is displayed here. Click the Show Network Password
box to be able to read the password, otherwise it is displayed in dots.
Changing the Wireless Password:
You can change the wireless password to a personalized one.
1. Highlight the old password and delete it.
2. Check the Show Network Password box to be able to read the password.
3. Enter your personalized network password and then click Save Settings at the bottom of
the page.
Label Description
To Next Page
Loading...
Need help?
General
