Ubiquiti EdgeRouter 12 User Manual

Using SFP Ports
To use an SFP port:
1. Remove the protective plug covering the SFP port.
2. Plug a fiber SFP module into the SFP port.
1000Mbps SM/SC 20KM DDM
Tx1550nm/Rx1310nm
3. Connect a fiber optic cable to the fiber SFP module. Then
connect the other end of the cable to another fiber device.
For information about compatible fiber SFP modules, visit:
ubnt.link/SFP_DAC_Compatibility

Ubiquiti EdgeRouter 12 Specifications

General

RAM	1 GB DDR3
Flash Storage	4 GB eMMC
Total Ports	12
Gigabit RJ45 Ports	10
SFP Ports	2
Max Power Consumption	20W
Operating System	EdgeOS
Layer 3 Forwarding Performance	3.4 million pps
Total Non-Blocking Throughput	10 Gbps
Certifications	CE, FCC, IC
Power Supply	24V, 1A
Supported Voltage Range	100-240V
Operating Humidity	10 to 90% Noncondensing
Operating Temperature	-10 to 45° C