Ubiquiti EdgeRouter LITE User Manual

Interface Description
Reset
There are two methods to reset the
EdgeRouter Lite to factory defaults:
• Runtime reset (recommended) The
EdgeRouter Lite should be running after
bootup is complete. Press and hold the
Reset button for about 10seconds until
the right LED on port eth2 starts flashing
and then becomes solidly lit. After a
few seconds, the LED will turn off, and
the EdgeRouter Lite will automatically
reboot.
• Power-on reset Disconnect the Power
Cord from the Power Adapter. Press and
hold the Reset button while connecting
the Power Cord to the Power Adapter.
Keep holding the button until the right
LED on port eth2 starts flashing and then
stops flashing after a few seconds.

Ubiquiti EdgeRouter LITE Specifications

General

Processor	Dual-Core 500 MHz MIPS64
RAM	512 MB
Flash Storage	2 GB
Max Power Consumption	7 W
Operating System	EdgeOS
Operating Temperature	-10 to 45° C
Operating Humidity	10 to 90% Noncondensing
Certifications	CE, FCC, IC
Ports	3 Gigabit RJ45
Power Input	12V DC
Power Supply	External AC/DC Adapter
Routing Capacity	1 million packets per second (64-byte)
Power Method	External AC/DC Adapter