Hardware Overview
Front Panel Ports
eth0 eth1 eth2
Console
Reset
Ethernet (eth0-eth2)
Interface Description
Console
RJ45 serial console port for Command
Line Interface (CLI) management. Use a
RJ45‑to‑DB9, serial console cable, also
known as a rollover cable, to connect the
Console port to your computer. (If your
computer does not have a DB9 port, then
you will also need a DB9 adapter.) Then
configure the following settings as needed:
• Baud rate 115200
• Data bits 8
• Parity NONE
• Stop bits 1
• Flow control NONE
Ethernet
(eth0‑eth2)
10/100/1000 Mbps Ethernet ports.
To Next Page
Loading...
