Need help?Do you have a question about the Ubiquiti EdgeSwitch ES-16-150W and is the answer not in the manual?
General| Total Ports | 16 |
|---|---|
| PoE Ports | 16 |
| PoE Budget | 150W |
| Switching Capacity | 32 Gbps |
| Forwarding Rate | 23.8 Mpps |
| Operating Humidity | 10 to 90% non-condensing |
| Jumbo Frame Support | Yes |
| VLAN Support | Yes |
| QoS Support | Yes |
| IGMP Snooping | Yes |
| STP/RSTP/MSTP | Yes |
| Link Aggregation | Yes |
| PoE | Yes |
| PoE+ IEEE 802.3at | Yes |
| 24V Passive PoE | No |
| Max. PoE+ Wattage per Port by PSE | 30W |
| Certifications | CE, FCC, IC |
| Power Input | 100-240VAC, 50/60Hz |
| Operating Temperature | -5 to 40 °C |
| Management Interface | CLI, SNMP |
| Layer | L2 |
| MAC Address Table Size | 8K |
| Interfaces | 16 x 10/100/1000 RJ45 |
Details the RJ45 and SFP ports found on the front panel of the EdgeSwitch device.
Explains the meaning and status indications of the system LED on the EdgeSwitch.
Describes the methods for performing a factory reset on the EdgeSwitch unit.
Provides instructions on obtaining an IP address for the EdgeSwitch using DHCP.
Outlines the FCC compliance statements and conditions for the EdgeSwitch.
Details Industry Canada compliance requirements for the EdgeSwitch device.
States compliance information and warnings for operation in Australia and New Zealand.
To Next Page