Ubiquiti EdgeSwitch - Connecting RJ45 Cables; Accessing Configuration Interface; DHCP Configuration

Connecting RJ45
Accessing the Conguration Interface
The EdgeSwitch is set to DHCP by default, so it will try to automatically obtain an IP address. If
that fails, then it will use the default fallback IP address, 192.168.1.2. Proceed to the
appropriate section, DHCP or “Fallback IP Address” :
DHCP
Use one of the following methods:
Set up the DHCP server to provide a specic IP address to the EdgeSwitch based on its
MAC address (on the label).
ES-12F Quick Start Guide
×
Click for
Table of Contents