Ubiquiti GigaBeam User Manual

GBE Ball Joint Mount Lock Ring
Metal Strap Gigabit PoE (24V, 0.5A) with
Mounting Bracket
Power Cord
Package Contents
Installation Requirements
Clear line of sight between GigaBeam AP and station
Pole-mounting: 7 mm socket wrench or screwdriver
Wall-mounting: wall fastener (not included)
Shielded Category 5 (or above) cabling with drain wire should be used for all wired
Ethernet connections and should be grounded through the AC ground of the PoE.
We recommend that you protect your networks from harmful outdoor environments
and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti.
For more details, visit ui.com/toughcable
Surge protection should be used for all outdoor installations. We recommend that you
use two Ethernet Surge Protectors, model ETH-SP-G2, one near the device and the other
at the entry point to the building. The ETH-SP-G2 will absorb power surges and safely
discharge them into the ground.
Note: For guidelines about grounding and lightning protection, follow your
local electrical regulatory codes.
GBE Quick Start Guide

Ubiquiti GigaBeam Specifications

General

Frequency	60 GHz
Throughput	1+ Gbps
Operating Temperature	-40 to 60° C (-40 to 140° F)
Max. Power Consumption	11W
Channel Bandwidth	2160 MHz
Encryption	AES-128
Operating Humidity	5 to 95% Noncondensing
Wind Survivability	200 km/h (125 mph)
Certifications	CE, FCC, IC
Antenna Gain	38 dBi
Networking Interface	10/100/1000 Ethernet Port
Power Method	Passive PoE
Mounting	Pole Mount
Enclosure Characteristics	UV Stabilized Polycarbonate
Wireless Security	WPA2
Dimensions	140 x 140 mm (5.51 x 5.51")
Power Supply	24V, 0.5A PoE adapter

Summary

Package Contents

Installation Requirements

Hardware Overview

Hardware Installation

Pole-Mounting

Step-by-step guide for attaching the device to a pole using the included mounting hardware.

Wall Mounting

Instructions for mounting the device to a wall, including optional accessories for stability.

Aiming

Connecting Power

Configuration

DHCP

Details on configuring the device using DHCP to obtain an IP address automatically.

Fallback IP Address

Procedure for accessing the device via a static fallback IP address if DHCP fails.

UNMS Management

Safety Notices

Limited Warranty

Compliance

FCC

Details on FCC compliance, including rules and conditions for operation.

ISED Canada

CAN ICES-3(A)/NMB-3(A)

Information regarding ISED Canada compliance and radio licensing requirements.

IMPORTANT NOTE

Radiation Exposure Statement

Guidelines on safe installation and operation to comply with radiation exposure limits.

CE Marking

Declaration of Conformity

Online Resources