Ubiquiti GBE - User Manual

To Next Page

GBE Ball Joint Mount Lock Ring

Metal Strap Gigabit PoE (24V, 0.5A) with

Mounting Bracket

Power Cord

Package Contents

Installation Requirements

Clear line of sight between GigaBeam AP and station

Pole-mounting: 7 mm socket wrench or screwdriver

Wall-mounting: wall fastener (not included)

Shielded Category 5 (or above) cabling with drain wire should be used for all wired

Ethernet connections and should be grounded through the AC ground of the PoE.

We recommend that you protect your networks from harmful outdoor environments

and destructive ESD events with industrial-grade, shielded Ethernet cable from

Ubiquiti. For more details, visit

ui.com/toughcable

Surge protection should be used for all outdoor installations. We recommend that

you use two Ethernet Surge Protectors, model ETH-SP-G2, one near the device and

the other at the entry point to the building. The ETH-SP-G2 will absorb power surges

and safely discharge them into the ground.

Note:

For guidelines about grounding and lightning protection, follow your

local electrical regulatory codes.

GBE Quick Start Guide

Certifications

CE, FCC, IC

Model

GBE

Networking Interface

1 x GbE RJ45 Port

Power Supply

24V, 0.5A Gigabit PoE Adapter

ESD/EMP Protection

± 24 kV (air)

Ethernet Ports

Operating Humidity