Ubiquiti LAP-GPS - Connecting to the PoE Adapter; Mounting the PoE Adapter (Optional)

3. Connect the power using:
● included Gigabit PoE Adapter
● PoE switch
Connecting to the PoE Adapter
1. Connect the Ethernet cable from the device to the POE port of the PoE
adapter.
2. Connect an Ethernet cable from your LAN to the LAN port of the PoE
adapter.
3. Connect the Power Cord to the adapter, and then plug the Power Cord
into a power outlet.
Mounting the PoE Adapter (Optional)
1. Remove the PoE Mounting Bracket from the adapter, place the bracket
at the desired location, and mark the two holes.
WARNING: The switch port must comply with the power specifications
listed in this Quick Start Guide.