To Next PageTo Next Page
Need help?Do you have a question about the Ubiquiti NanoStationM Series and is the answer not in the manual?
General| Ethernet Ports | 1 x 10/100 Mbps |
|---|---|
| Max. Power Consumption | 8W |
| RoHS Compliance | Yes |
| Product Line | NanoStation |
| Wireless Standards | 802.11n |
| Frequency Band | 2.4 GHz or 5 GHz (depending on model) |
| Max Throughput/Data Rate | 150 Mbps |
| Antenna Type | Integrated |
| Power Method | Power over Ethernet (PoE) |
| Power Supply | 24V, 0.5A PoE adapter |
| Operating Temperature | -30°C to 80°C |
| Mounting | Wall or pole mount |
| Processor Specs | MIPS 24K, 400 MHz |
| Memory Information | 32 MB RAM, 8 MB Flash |
| Networking Interface | 10/100 Ethernet |
| Wireless Approvals | FCC, CE, IC |
| Operating Humidity | 5% to 95% non-condensing |
| Shock and Vibration | ETSI300-019-1.4 |
Use shielded Category 5 cabling with a drain wire and ground it through the PoE AC ground.
Utilize two Ethernet Surge Protectors (ETH-SP) for outdoor installations to protect against power surges.
Avoid water submersion and electrical storms due to risks of damage or electric shock.
Use provided power cord, ensure proper grounding, and avoid adapter plugs for safety.
Ensure compliance, use qualified technicians for service, and follow wiring rules for safety.
Device adheres to FCC Part 15 rules for operation and interference.
Device complies with ISED Canada license-exempt RSS standards for operation.
