2021-06-18 08:10 1/2 Anleitung – Unbrick Nanostation
Netz39 - https://www.netz39.de/wiki/
Anleitung – Unbrick Nanostation
Manual for Unbrick a UBNT Nanostation
compatible for:
Nanostation M2
Nanostation M2 XW
Nanostation loco M2
Nanostation loco M2 XW
Nanostation M5
Nanostation M5 XW
Nanostation loco M5
Nanostation loco M5 XW
(1) Download the AirOS 5.5.x firmware executable from the Ubiquiti website. Choose XM or XW
version depending on your device, If you don’t know, take a guess!
XM.v5.5.11.28002.150723.1344.bin, changelog
for: AG-HP-2G16, AG-HP-5G23, AG-HP-5G27, AirGrid M2, AirGrid M5, AR, AR-HP, BM2HP,
BM2-Ti, BM5HP, BM5-Ti, LiteStation M5, locoM2, locoM5, locoM9, M2, M3, M365, M5,
M900, NB-2G18, NB-5G25, NBM3, NBM365, NBM9, NS2, NSM3, NSM365, NSM5, PBM10,
PBM3, PBM5, Power AP N
XW.v5.5.10-u2.28005.150723.1358.bin, changelog
for: AG-HP-2G16, AG-HP-2G20, AG-HP-5G23, AG-HP-5G27, AirGrid M, AirGrid M2, AirGrid
M5, locoM2, locoM5, locoM9, M2, M3, M365, M5, M900, NBE-M2-13, NBE-M5-16, NBE-
M5-19, NSM2, NSM3, NSM365, NSM5, PBM3, PBM365, PBM5, RM2-Ti, RM5-Ti
(2) Start device into config/maintenance mode: in this precise order, unpower device,
configure PC into static IP 192.168.1.3 Netmask 255.255.255.0
press and maintain reset button
plug device in, release reset button as soon as LEDs blink (please wait 20-30 seconds)
(note 1: LED blink pattern is different depending on device: Sometimes a single LED blinking 3/4
on, 1/4 off, sometimes two LEDs blinking "sideways")
(note 2: the static-IP connection to the device must be established before it boots into config
mode. It was tricky rebooting the device fast enough that the PC connection did not go down.
YMMV.)
(3) TFTP the AirOS 5.5.x firmware into the device:
tftp 192.168.1.20
(note: use this IP regardless of what firmware is already on the device)
To Next Page
Need help?
General
