NINA-W1 series - System integration manual
UBX-17005730 - R11 Software Page 24 of 55
C1 - Public
• RESET to IO19 (CTS)
• IO0 (IO zero) to IO26 (DSR)
The jumpers CTS (J14-8) and DSR (J14-7) should also be removed so that they do not interfere.
☞ It is not possible to use the Hardware Flow control or the DSR signals on the UART while using this
setup.
More information about the esptool is available at - https://github.com/espressif/esptool
2.8 Arduino support for NINA-W10
It is possible to use Arduino electronics platform on the NINA-W10. The Arduino platform and open
source community provides the possibility to access a lot of third party hardware such as displays and
sensors.
2.8.1 Downloading the Arduino IDE
Windows, Mac, and Linux environment are supported. The example below uses the Windows
environment. Download the Arduino IDE using the URL - https://www.arduino.cc/en/Main/Software.
Figure 17: Screenshot during installation of the Arduino IDE
Click Install button in the dialog box that pops up during installation as shown in the screenshots
below:
To Next Page
Loading...
