NINA-W1 series - System integration manual
UBX-17005730 - R11 Software Page 31 of 55
C1 - Public
init_data[73] = 0x10;//channel 12
init_data[74] = 0x10;//channel 13
init_data[75] = 0xAA;//channel 14
init_data[76] = 0x44; //channel 3, 4
init_data[77] = 0x44; //channel 5, 6
init_data[78] = 0x44; //channel 7, 8
init_data[79] = 0x44; //channel 9, 10
init_data[80] = 0x44; //channel 11
apply_rf_frequency_calibration(init_data);
ESP_LOGD(TAG, "loading PHY init data from application binary");
return (esp_phy_init_data_t*)init_data;
}
2.9.1.3 Bluetooth BR/EDR output power configuration
No output power configuration for Bluetooth BR/EDR is required. With default settings, the module
will operate at ~6 dBm, which is within the regulatory limit for NINA-W1.
2.9.1.4 Bluetooth low energy output power configuration
No output power configuration for Bluetooth low energy is required. With default settings, the module
will operate at ~6 dBm, which is within the regulatory limit for NINA-W1.
2.9.2 NINA-W13/W15 series
No output power configuration required by the integrator. Using the u-connectXpress guarantees
operation within regulatory limits.
To Next Page
Loading...
