Ublox NINA-W106 - Approvals; General Requirements; FCC;IC End-Product Regulatory Compliance; NINA-W10 Series FCC ID and IC Certification Number

NINA-W1 series - System integration manual
UBX-17005730 - R11 Approvals Page 47 of 55
C1 - Public
Approvals
⚠ Country approval for NINA-W1x6 is pending.
For additional regulatory information, see the NINA-W1 series Data Sheets [2]/[3]/[4].
5.1 General requirements
The NINA-W1 series modules comply with the regulatory demands of Federal Communications
Commission (FCC), Industry Canada (IC)
2
and the CE mark. This section provides the instructions that
must be followed by an integrator while including NINA-W1 series into an end product.
• Any changes to hardware, hosts or co-location configuration may require new radiated emission
and SAR evaluation and/or testing.
• The regulatory compliance of NINA-W1 series does not exempt the end product from being
evaluated against applicable regulatory demands; for example, FCC Part 15B criteria for
unintentional radiators [9].
• Only authorized antenna(s) may be used.
• Any notification to the end user about how to install or remove the integrated radio module is NOT
allowed.
5.2 FCC/IC End-product regulatory compliance
u-blox warrants that the modular transmitter fulfills the FCC/IC regulations when operating in
authorized modes on any host product given that the integrator follows the instructions as described
in this document.
5.2.1 NINA-W10 series FCC ID and IC certification number
u-blox FCC ID and IC certification number for NINA-W10 series is restricted to be used by u-blox only.
Integrators other than u-blox may not refer to the u-blox FCC ID and IC certification number on their
end product.
Following the processes called “Change in ID” (FCC) and “Multiple listing” (IC), an integrator can use
all the certifications done by u-blox. Through these processes, the integrator becomes the grantee of
a copy of the original u-blox FCC/IC certification. As grantee, the integrator is free to perform any
updates to the new certification if needed; for example, adding new antennas to the authorization for
NINA-W101 module using the antenna pin.
u-blox will guide customers through this process and support with the approval letter that shall be
filed as a Cover Letter exhibit with the application to the authority.
⚠ It is the responsibility of the integrator to comply with any upcoming regulatory requirements.
5.2.2 NINA-W13/W15 series FCC ID and IC certification number
An end product integrating the NINA-W13 series or NINA-W15 series module using u-connectXpress
can refer to the u-blox FCC ID and IC certification number.
u-blox can support updates to the u-blox regulatory authorization, if needed. For example, adding new
antennas to the u-blox authorization for NINA-W131 module using the antenna pin.
2
Official name is Innovation, Science and Economic Development (ISED) Canada.