This functionality is only available for radios equipped
with a Satellite receiver. In order to receive satellite radio,
the vehicle needs to be outside with a clear view to the
sky.
If the screen shows Acquiring Signal, you might have to
change the vehicle’s position in order to receive a signal.
In most cases, the satellite radio does not receive a signal
in underground parking garages or tunnels.
Audio
1. Press the SETTINGS hard-key on the right side of the
unit.
2. Then scroll down and press the Audio soft-key to get
to the Audio menu.
3. The Audio Menu shows the following options for you
to customize your audio settings.
Equalizer
• Touch the Equalizer soft-key to adjust the Bass, Mid
and Treble. Use the + or - soft-key to adjust the
equalizer to your desired settings. Press the back
arrow soft-key when done.
Balance/Fade
• Touch the Balance/Fade soft-key to adjust the sound
from the speakers. Use the arrow soft-key to adjust the
sound level from the front and rear or right and left
side speakers. Touch the Center 9C9 soft-key to reset
the balance and fade to the factory setting. Press the
back arrow soft-key when done.
Speed Adjustable
• Touch the Speed Adjusted Volume soft-key to select
between OFF, 1, 2 or 3. This will decrease the radio
volume relative to a decrease in vehicle speed. Press
the back arrow soft-key when done.
Loudness
1
Uconnect™ ACCESS USER’S MANUAL 27
To Next Page
Loading...
Need help?
General
