Receiving A Call – Accept (And End)
When an incoming call rings or is announced on
Uconnect™, press the Phone button.
To end a call, press the Phone button on steering wheel or
the Phone soft-key on the radio screen.
Mute (Or Unmute) Microphone During Call
During a call, press the “Voice Command” button.
(After the BEEP), say “mute” (or “mute off”).
Transfer Ongoing Call Between Handset And Vehicle
During a call, press the “Voice Command” button.
(After the BEEP), say “transfer call”.
Changing The Volume
Start a dialogue by pressing the “Phone” button , then
adjust the volume during a normal call.
Use the radio VOLUME rotary knob to adjust the volume
to a comfortable level while the Uconnect™ system is
speaking. Please note the volume setting for Uconnect™
is different than the audio system.
Uconnect™ Voice Command
The Uconnect™ Voice Command system allows you to
control your AM, FM, satellite radio, CD player,
Uconnect™ Phone and supported portable media de-
vices.
When you press the “Voice Command” button located on
the steering wheel, you will hear a beep. The beep is your
signal to give a command. If you do not say a command
within a few seconds, the system will present you with a
list of options. If you ever wish to interrupt the system
while it lists options, press the “Voice Command” button
, listen for the BEEP, and say your command.
Voice Command Operation
1
Uconnect™ ACCESS USER’S MANUAL 35
To Next Page
Loading...
