Ultra Start 1155 Series

To Next Page

INSTALL GUIDE

www.ultrastarters.com

Technical Support: 866-698-5872 ext 0

support@ultrastarters.com

Covers the installation of the

1155 Series Remote Starter

The system must be placed into Service Mode before any service work is started on the

vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The

manufacturer accepts no liability or responsibility for accidental starting of the vehicle.

CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)

- The Hood Pin Safety Switch Must Always be Installed!

Warning!!

CARBON MONOXIDE MAY CAUSE SERIOUS INJURY, EVEN DEATH!

It is the sole responsibility of the user to place the system in Service Mode

when parking in an enclosed area ex: garage, partially enclosed area

ex: carport, or when the vehicle is being serviced.

REV.2006.01

Main Page

Need help?

Do you have a question about the Ultra Start 1155 Series and is the answer not in the manual?

Summary

Service Mode Operation

Activating and Deactivating Service Mode

Procedures for enabling and disabling valet mode for vehicle service.

Wiring Diagram and Connections

6 Pin Power Connector Wiring

Details the electrical connections for the 6-pin power harness.

14 Pin Connector Wiring

Details the electrical connections for the 14-pin auxiliary harness.

Wiring Connections Details

6 Pin Power Connector Pinout

Lists the function and voltage for each wire in the 6-pin connector.

14 Pin Connector Pinout

Lists the function and voltage for each wire in the 14-pin connector.

Quick Start Install

Step 1: Wire Connections

Outlines the essential wire connections for both 6-pin and 14-pin connectors.

Step 2: Auto Tach;Tachless Learning

Guides through the process of teaching the system the engine's tach signal.

Programming and System Reset

Entering Program Mode

Changing Programmable Settings