Why is my Ultra Start Remote Starter not remote starting?
If your Ultra Start remote starter isn't starting your vehicle, there are a few things to check. First, count the park light flashes and then consult the diagnostics page. Check the battery voltage in the remote. Ensure you are within the operating range. Verify that the vehicle's anti-theft system isn't activating. Finally, try reprogramming the remotes using Transmitter Program Mode.
What to do if my Ultra Start 72 Series system does not respond to the remote transmitter?
If your Ultra Start remote starter system isn't responding to the remote transmitter, try these steps: First, try using your second remote. Check the batteries in the remote. Reprogram the remotes using Transmitter Program Mode. Also, make sure you are within operating range.
Why does my Ultra Start 72 Series Remote Starter vehicle start then shut off by itself?
If your vehicle starts and then shuts off by itself when using the Ultra Start remote starter, check if the vehicle anti-theft is activating. Also, check if the starter motor is staying on too long; if it is, reprogram the tach and try again. If the problem persists, consult a dealer.
What to do if the doors do not lock or unlock with my Ultra Start 72 Series?
If the doors aren't locking or unlocking with your Ultra Start remote starter, first check if this optional feature was installed. Have your installer check the door lock connector. Also, have the bypass or keyless module reprogrammed.
How to stop lights on the antenna from flashing on my Ultra Start Remote Starter?
When the doors are locked by the remote, the LEDs will flash until the unlock button is pressed. If you do not want the LEDs to flash, have your installer program the LED flashes off.
Why does the horn not honk with my Ultra Start 72 Series Remote Starter?
If the horn isn't honking with your Ultra Start remote starter, first verify if this optional feature was installed. Try panic mode to see if the horn activates. If not, have the system's horn output checked.
Procedure to activate and deactivate Valet Mode or Emergency Override.
Operations for remote starting, key takeover, idle modes, and extended runtime.
Functions for locking, unlocking doors, and trunk release.
Activation of panic mode, silent lock/unlock, and car finder.
Activation of auxiliary outputs for custom applications.
Steps to activate and deactivate Emergency Override Mode.
Instructions for setting and canceling the automatic start interval.
Steps to enter programming mode and pair new remotes.
Describes button functions and LED/beep feedback for 2-way systems.
2-way operation for panic, trunk release, and cold start modes.
Indicates low battery voltage on the remote.
Addresses common issues like no remote start, or system not responding.
Troubleshooting start faults using park light and LED flash codes.
General| Operating Range | Up to 1, 500 feet |
|---|---|
| Number of Buttons on Remote | 4 |
| Security Features | Anti-grind, starter kill |
| Remote Start | Yes |
| Keyless Entry | Yes |
| Confirmation | Audible and visual confirmation |
| Compatibility | Most vehicles |
| Engine Immobilizer Bypass | Yes, with additional module |
| Battery Life | Up to 1 year |
| Warranty | Limited Lifetime |
To Next Page
