How to troubleshoot if my ULTRASOURCE Kitchen Appliance machine will not start?
If your ULTRASOURCE Kitchen Appliance machine won't start, ensure the power requirements match those on the nameplate. Also, inspect fuse F-3 and replace it if it's blown. Another possible solution is to check the overload OL-1 and reset it if needed.
What to do if my ULTRASOURCE Kitchen Appliance has improper or no sealing?
If your ULTRASOURCE Kitchen Appliance is not sealing properly, ensure the regulator knob is fully clockwise, or if using air-assist, set it to the recommended pressure. Check the seal bladder valve SOL-3 for proper operation, and inspect the seal bar connection points and clips for corrosion and proper tension. Also, check for a broken seal element, and verify the seal bar fuse F-1 for the front seal bar and F-2 for the rear seal bar. Finally, ensure the seal impulse potentiometer POT-3 is set high enough, or check for a defective control module.
Why is there no vacuum in my ULTRASOURCE Kitchen Appliance?
If your ULTRASOURCE Kitchen Appliance has no vacuum, check the lid switches LS-1 and LS-2 for proper adjustment. Also, inspect the intake screen in the vacuum pump hose barb for blockages, such as pieces of bags, labels, or bone.
What to check if front or rear seal bar is heating, but not both, in ULTRASOURCE Kitchen Appliance?
If either the front or rear seal bar is not heating on your ULTRASOURCE Kitchen Appliance, check the seal bar fuse F-1 for the front seal bar and F-2 for the rear seal bar.
What to do if chamber is not venting on ULTRASOURCE Kitchen Appliance?
If your ULTRASOURCE Kitchen Appliance chamber is not venting, check the ventilation valve SOL-4 for proper operation. A defective control module might also be the cause.
Why is there no gas flush in my ULTRASOURCE Kitchen Appliance?
If your ULTRASOURCE Kitchen Appliance has no gas flush, first, check for proper gas pressure going into the gas inlet. Second, check for proper operation of the gas flush valve (SOL-2). Finally, a possible defective control module may be the cause.
What causes gas to flush to one chamber side only in ULTRASOURCE Kitchen Appliance?
If gas flushes to one chamber side only in your ULTRASOURCE Kitchen Appliance, check the gas flush selector valve (V-1) for proper adjustment.
Table detailing dimensions, pump, cycle time, weight, and construction.
Procedures and guidelines to avoid property damage and personal injury.
Steps for unpacking and connecting power, including cable sizing.
Importance and procedure for grounding the machine for shock prevention.
Features and capabilities of the digital control panel and its menus.
Table of common problems, indications, and remedies.
Step-by-step instructions for changing vacuum pump oil and filter.
General| Brand | ULTRASOURCE |
|---|---|
| Model | ULTRAVAC 2100 |
| Category | Kitchen Appliances |
| Language | English |
To Next Page