Ulvac PKS-030 - Page 11

-9-
2) It is recommendable to install a vacuum valve [A] between the equipntent
and the pump. (See Fig. 2)
[Fig. 2]
Standard vacuum system piping for PKS
When the pump stops, close vacuum valve [A] to keep the equipment under
vacuum, then open leak valve [B] to vent the pump, thus preventing oil
counter-flow within the pump.
3) It is advisable to install a metallic flexible connection between the pump
intake and vacuum piping to eliminate vibration.
Caution:
Awirenet(i.e.,suctionfilter)isprovidedwithinthepump
intaketopreventlargersolidsfromenteringthepump.Pleasedo
notremovethiswiremesh.
Note:
Thisnetshouldbecleanedperiodicallyaccordingtoyourspecific
maintenanceschedule.

