Ungo ProSecurity K20 - Page 15

Ungo ProSecurity
136
RK1: Remote Start/Keyless Entry System
Factory default settings are indicated in
bold
in the following feature tables.
MENU #1
Feature Default LED ON Setting LED OFF Setting
Number (Press "LOCK" Button) (Press "UNLOCK" Button)
1
Active Mode
Passive Mode
2
Chirps ON
Chirps OFF
3
Ignition Lock ON
Ignition Lock OFF
4
Ignition Unlock ON
Ignition Unlock OFF
5
Active Locking
Passive Locking
6
Panic with Ignition ON
Panic with Ignition OFF
7
Door Lock Pulse Duration 0.8 Seconds
Door Lock Pulse Duration 3.5 Seconds
8
Double Unlock Pulse OFF
Double Unlock Pulse ON
9
Channel 2 Delayed Validity
Channel 2 Latched (2), Latch Reset with
Ignition (3), 30-Second Timed (4)
10
Factory Alarm Disarm w/Channel 2 ON
Factory Alarm Disarm w/Channel 2 OFF
11
Security Features ON
Security Features OFF
12
Code Hopping ON
Code Hopping OFF
13
Channel 4 Validity
Channel 4 Latched (2), Latch Reset with
Ignition (3), 30-Second Timed (4)
* NOTE: The numbers in parentheses indicate the number of times the LED will flash.
Factory default settings are indicated in
bold
in the following feature tables.
MENU #2
Feature Default LED ON Setting LED OFF Setting
Number (Press "LOCK" Button) (Press "UNLOCK" Button)
1
Engine Check ON
Engine Check OFF
2
Tachometer Engine Check
Voltage Engine Check
3
12 Minute Run Time (1)
24 Minutes (2), 60 Minutes (3) Run Time
4
Flashing Parking Light Output
Constant Parking Light Output
5
Cranking Time 0.6 sec. (1)
Crank Time: 0.8 (2), 1.0 (3), 1.2 (4), 1.4 (5)
6
Voltage Level High Check
1.6 (6), 1.8 (7), 2.0 (8), 4.0 (9) Seconds
7 Activation Pulse: 1 (1)
Activation Pulses: 2 (2)
, 3 (3)
8
2nd Ignition Output
2nd Accessory Output
9
Acc. State During Wait to Start OFF
Acc. State During Wait to Start ON
10
2nd Status Output Normal
Rear Defogger Latched (2), Rear Defogger
Pulse (3)
11
Anti-Grind ON
Anti-Grind OFF
* NOTE: The numbers in parentheses indicate the number of times the LED will flash.