Ungo ProSecurity K20 - Transmitter;Receiver Learn Routine

Ungo ProSecurity
Transmitter/Receiver Learn Routine
Ungo ProSecurity come with either one or two transmitters that have been programmed to the receiver. Use the
following learn routine to add transmitters to the system or to change button assignments if desired.
The Valet/Override button must be in working order and plugged into the blue port on the Ungo ProSecurity system.
There is a basic sequence to remember whenever programming a system: Door, Key, Choose, Transmitter and
Release.
Procedure:
1. Open a door.
2. Turn the ignition On
3. Press and release the Valet/Override switch the number of times necessary to access the desired channel, then
press the switch once more and Hold it. The siren (or horn) with chirp and the LED will blink the number of times
corresponding to the channel that has been accessed.
K10, K20, RK1, RS10, S100, S400, S660, S670, SR1000, SR5000, SR6000, SR9000
4. While holding the Valet/Override switch, press the button on that you would like to control the selected receiver
channel. The unit will chirp to confirm that code has been successfully programmed. It is not possible to teach a
remote button to the system more than once.
5. Once the code is learned, the Valet/Override switch can be released.
RK20, SR7000
4. While holding the Valet/Override switch, press the “LOCK” button on the remote control. The siren chirps to confirm
that the code has been successfully programmed or the selected feature has been reset. It is not possible to teach a
remote control button to the system more than once.
5. Once the code is learned, or the feature reset, the Valet/Override switch can be released.
130
K10: Keyless Entry System
Replacement Remote Transmitter: SAA474U
Replacement Battery: CR2032
Ch. Number Function Wire Color
1 Arm/Disarm/Panic
2 Silent Mode/Remote Override/Trunk Release Red/White
3 Remote Engine Start or Other Accessory White/Blue
4 Arm Only
5 Disarm Only
6 Panic Only
7 Auto-Learn Single Button Arm/Disarm Configuration
8 Auto-Learn Standard Configuration
9 Delete All Remotes
K20: Keyless Entry System
Replacement Remote Transmitter: SAA474U
Replacement Battery: CR2032
Ch. Number Function Wire Color
1 Auto-Learn
2 Arm (Lock) Only
3 Disarm (Unlock) Only
4 Channel 2 Red/White
5 Channel 3 White/Blue
6 Arm/Disarm/Panic
7 Panic Only
8 Delete All Remotes