Ungo ProSecurity
Valet Mode
To Enter or Exit Valet mode with the Valet/Override Switch:
Procedure:
1. Turn the ignition key ON and then OFF
2. At anytime during the next 10 seconds, press and release the Valet/Override switch. Now the status LED will glow
constantly if you have entered Valet mode, and goes out if you have exited Valet mode.
To Enter or Exit Valet mode with the remote transmitter:
Procedure:
1. Open any door.
2. Press the “LOCK” button on the transmitter.
3. Press the “UNLOCK” button on the transmitter.
4. Press the “LOCK” button on the transmitter. Now the status LED will glow constantly if you have entered Valet
mode, and goes out if you have exited Valet mode.
Tach Learning
To learn the tach signal:
Procedure:
1. Start the vehicle with the key.
2. Within 5 seconds, press and HOLD the Valet/Override switch.
3. The LED will glow constantly when the tach signal is learned.
4. Release the Valet/Override switch and turn off the vehicle.
Timer Mode
Timer mode can only be accomplished when using the “LOCK” and “UNLOCK” buttons the parking lights will flash 4
times and then start the vehicle and run for the set duration. The remote start can be shut off by the transmitter by
pressing the remote start button “ ” or the “SIREN” icon button on LCD remote transmitters and remain in timer
mode, but if any other shut down zone or the ignition becomes active the timer mode will cancel.
Procedure:
1. Press the “LOCK” and “UNLOCK” buttons together.
2. The vehicle confirms with 4 parking light flashes.
3. A 1-second delay will start.
4. The system will start the vehicle and will run for the specified duration, unless shut down by the remote start button
“ ” or the “SIREN” icon button on LCD remote transmitters. If shut down with the remote start button “ ” or the
“SIREN” icon button on LCD remote transmitters the system will remain in timer mode.
5. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires. To exit
timer mode, turn the ignition switch on any time the engine is not running. The parking lights will flash 4 times indicat-
ing timer mode has been exited.
6. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires.
146
*
*
*
To Next Page
Loading...