User’s Manual UDP6900 Series Digital Control Power Supply
Instruments.uni-trend.com 23 / 44
5. Click on the Manage button to select the file to save or input the filename and save to the specified
storager;
Note: Delayer data is not saved automatically and needs to be saved manually.
Delayer Page
Template Settings
Press Template to enter the following page.
1. Click on the Edit Object button or rotate the encoder knob to switch to the template of the delayer;
2. Click on the Start Point button to numbering the start point;
3. Click on the Total Point button to set the number of point that required by the delayer of this time;
(the maximum sum of the start point and the total point is 512);
4. State code is used to set the template state;
5. Duration template is used to set the time change;
Fixed duration represents the switch time of the template is fixed;
Duration increment/decrement represents each point in the template will step change according to
the settings.
6. After the above settings is finished, click on the Generate button to complete the delay template
output settings.
Template: this product provides four delayer templates, user can select it according to the application fields.
1. State Code
"0" represents the output is off; 1 represents the output is on;
The "01 code" mode indicates that start from the start point is the closed state, until the total points
are all set to follow the cycle state of "01";
To Next Page
Loading...
