to the10A terminal.
MAINTENANCE
This section provides basic maintenance information including
battery and fuse replacement instruction.
performance test, and service information.
water inside the case.
field.
To test the fuse:
Do not attempt to repair or service your Meter unless you
are qualified to do so and have the relevant calibration,
Warning
To avoid electrical shock or damage to the Meter, do not get
A. General Service
l
l Periodically wipe the case with a damp cloth and mild
detergent. Do not use abrasives or solvents.
l To clean the terminals with cotton bar with detergent, as dirt
or moisture in the terminals can affect readings.
l Turn off the power of the Meter when it is not in use and take
out the battery when not using for a long time.
Take out the battery when it is using for a long time.
l Do not use or store the Meter in a place of humidity, high
temperature, explosive, inflammable and strong magnetic
B. Testing the Fuses
fuses with identical amperage, voltage, and speed ratings.
To avoid electrical shock or personal injury, remove the test
leads and any input signals before replacing the battery or
fuse.
To prevent damage or injury, install ONLY replacement
Warning
1. Model UT60C/UT60E: Set the rotary switch to
.
Model UT60B: Set the rotary switch to and press
BLUE button to select .
2. Plug a test lead into the terminalHzV
and touch the probe
and pressBLUE button to select
31
To Next Page
Loading...
Need help?
General
