Qty
1 piece
1 pair
1 pair
1 piece
1 piece
1 piece
1 piece
Item
1
2
3
4
5
6
7
Description
Operating Manual
Test Lead
Test Clip
Model UT60E:CD-ROM (Installation
Guide & Computer Interface Software)
Model UT60C/UT60E:Point
Contact Temperature Probe
Model UT60E:RS232C Interface Cable
9V Battery (NEDA1604, 6F22 or 006P)
(installed)
Model UT60B/C/E: OPERATING MANUAL
CAT IV: Primary supply level, overhead lines, cable
systems etc.
4
Unpacking Inspection
Open the package case and take out the Meter. Check the
following items carefully to see any missing or damaged part:
In the event you find any missing or damage, please
contact your dealer immediately.
Safety Information
This Meter complies with the standards IEC61010: in
pollution degree 2, overvoltage category (CAT. III 1000V,
CAT. IV 600V;)and double insulation.
CAT. III: Distribution level, fixed installation, with smaller
transient overvoltages than CAT. IV
Use the Meter only as specified in this operating manual,
otherwise the protection provided by the Meter may be
impaired.
In this manual, a Warning identifies conditions and
actions that pose hazards to the user, or may damage
the Meter or the equipment under test.
A Note identifies the information that user should pay
attention on.
International electrical symbols used on the Meter and
in this Operating Manual are explained on page 6.
To Next Page
Loading...
Need help?
General
