UTD2000 Series User Manual
37
Chapter VI Display System
As shown in the figure below, the DISPLAY on the control area is the function button of
Display System.
Figure 6-1 Function Keys of Display System
Press DISPLAY button to enter display setting menu as shown in the table below.
Table 6-1 Display Menu (Page 1)
Function Setting Description
Types
Vector Display sampled points in connection way.
Dots Only display sampled data points.
Persistance Set OFF, AUTO, Short persistence, Long Persistence, infinite.
Menu Set 5s, 10s, 20s, manualy.
Screen
protection time
Set OFF, 1min, 5min, 10min, 30min, 1 hour.
Next page Go to next page
Table 6-2 Display Menu (Page 2)
Function Setting Description
Waveform
brightness
10%-
100%
Set waveform brightness
Grid
brightness
10%-
100%
Set grid brightness
Backlight 10%-
100%
Set backlight brightness
Grid Set full grid, lattice, cross grid, frame
Previous Go to previous page
Key point:
Display type: The vector will fill the blank between adjacent sampled points. The Dots only
displays sampled points.
To Next Page
Loading...
