Need help?Do you have a question about the UNI-T UTD2025 series and is the answer not in the manual?
General| Bandwidth | 25MHz |
|---|---|
| Channels | 2 |
| Sampling Rate | 250MS/s |
| Power Supply | 100-240VAC, 50/60Hz |
| Weight | 2.2kg |
| Trigger Types | Edge, Pulse, Alternate |
| Interfaces | USB Device, USB Host |
| Time Base | 5 ns/div to 50 s/div |
Details the minimum system requirements for installing the communication and control software.
Guides users through the installation wizard, including setup steps and completion.
Explains the methods to run the installed oscilloscope communication and control software.
Provides instructions on installing the necessary USB driver for device communication.
Describes the main interface and components of the virtual control panel.
Details saving, loading, and recording waveforms via the Document menu.
Explains waveform playback options and software functions like mathematics.
Provides detailed explanations of the functions of each key on the control panel.
Guides on using serial and single transmission modes and related operational notes.
Guides users on connecting and operating the oscilloscope via USB interface.
Details setup for remote control and measurement using the Ethernet (LAN) connection.
Explains how to connect and operate the oscilloscope using the GPIB interface.
Explains common system prompts encountered during operation and their meaning.
Provides steps to troubleshoot configuration, driver update, and communication problems.
To Next Page