UNI-T UTD2025 series User Manual

Uni
-
Trend Technology (Chengdu) Ltd
.
Page
25
of
27
Communica
tion & Control So
ftware for
UTD20
25
_30
25
Series Oscilloscopes
User
Manual
Chapter 4
System Prompts and Trouble
-
shooting
4.1 System p
rompts
Time out prompt : Check the communication interface configuration. See whether the equipment is properly
connected and check software driver update.
SCAN prompt : SCAN will perform single transmission. Please carry out single refresh. Continue?
A
re you sure you want to exit Virtual Instrument? A prompt to ask you if you wish to close the software.
4.2 Troubleshooting
1.
If the system prompts you to check serial or USB configuration when you enter [Equipment ON/OFF], take
the following steps :

Check whether the oscilloscope power plug is properly connected.

Check whether oscilloscope ports match the communication and control software setups.

Check whether the cable connection between module and PC is in order.

Ensure the USB driver
is properly installed.

After carrying out the above checks, restart the software and oscilloscope to continue operation.
2.
If you are unable to update the software driver, take the following steps :

Right click the box on your computer desk
-
top as sh
own in Fig 4
-
1 to activate the right
-
click menu in Fig
4
-
2.
Fig 4
-
1
Fig 4
-
2

UNI-T UTD2025 series Specifications

General

Brand	UNI-T
Model	UTD2025 series
Category	Test Equipment
Language	English