Unic Phoenix-R - Programing of the Different Coffee Quantities in the Cup

- 5 -
6. PROGRAMING OF THE DIFFERENT COFFEE QUANTITIES IN THE CUP
P1 P2 P4
P5
The keys from P1 à P4 can be programmed.
1
Set the machine switch to Position 0.
2
Keep the key P5 pressed and put again the machine on.
Display of Pn then Pc and Pr by pressing several times the key P5
Pc = CALCULATED PROGRAMMING
Insert a filter-holder ( with coffee ) into the unit
Install one cup
" P5
Display Pc
" P1 à P4
Select the dose to be programed (1c for example)
" P5
Start the infusion cycle
" P5
Press again to stop when the amount of coffee desired is correct.
Display of the corresponding digital value ( from 00 à 99 )
3
Repeat operation at 3 for the other doses ( 1C for example)
Pn = DIGITAL PROGRAMMING
Quick programming without coffee and/or values carried foward on other units.
" P5
Display Pn
" P1 à P4
Select the dose to be programed
" P5
Dispaly of the digital value of the selected dose
" P1
Increase the value
" P4
Reduce the value
ε P5
Memorize the new value
4
Repeat operation at 4 for the other dose