Unical HP OWER 320RK - Accessing the Inner Parts; Costumised Chapters for each Series

16
329
309
P1
P2
P3
P4
[ 1 ]
[ 2 ]
A
B
1. Remove the two access panels to the components compartment by removing the screws as shown in figure 1. 2. To
access
the power supply terminal block, remove panel A by unscrewing the screws as shown in figure 2.
3.
To access the user terminal block, remove panel B by unscrewing the screws as shown in figure 2. 4.
Insert
the cables in the cableshot provided on the rear side of the machine to connect them to the system.
5. Close the electrical panel and the access panels to the machine components compartment using the screws previously removed.
The ideal installation positions of the dampers for each type of machine are shown in the below images.
5.7 ACCESSING THE INNER PARTS
5.7.1 Costumised chapters for each series