Unical HP OWER 320RK - Page 71

30
Danger Indication / Instruction Residual risk
User / Activity
Operator
User
Transport phase
Installation phase
Maintenance phase
Unit interaction
Normal unit operation
Mechanical: crushing caused by
the possible instability of the unit
during handling
The procedures for correct unit
handling and installation are
indicated on the user-installer
manual under chapter 5, with in-
dication of the center of gravity,
of the lifting points and equip-
ment. Protection devices use is
also recommended as required
by current regulations.
Failure by the installer to comply
with the installation procedures.
X X
Mechanical: crushing caused by
the possible instability of the unit.
The procedures for proper unit
installation are indicated on
user-installer manual under
chapter 5.
Failure by the installer to comply
with the installation procedures.
X X
Mechanical: Cutting / sectioning
/ shearing caused by the fan not
protected against accidental
contacts
The user-installer manual under
chapter 9 contains specific warn-
ings, also relating to the routine
maintenance phases.
Removal of the protection grid
by the user or maintenance
technician.
X X
Entanglement caused by the fan
not protected against accidental
contacts
The user-installer manual under
chapter 9 contains specific warn-
ings, also relating to the routine
maintenance phases.
Removal of the protection grid
by the user or maintenance
technician.
X X
Mechanical: cutting / abrasion
due to contact with the heat
exchange coil
The user-installer manual under
chapter 9 contains specific
warnings to be taken into consid-
eration when working near the
battery.
Failure to observe the warnings
in the manual and on the label.
X X
Mechanical: slipping / falling
caused by ice / water near the
unit as a result of water leaks
In the user-installer manual
under paragraph 5.8 is recom-
mended to pay attention to the
conveyance of the safety valve
and in paragraph 5.4 there are
indications regarding the surface
on which the unit rests. During
maintenance, the use of PPE and
the possible removal of all water
residues near the machine after
intervention is recommended..
Failure to comply with the in-
structions given in the manual.
X X