3 MONTHS (600 OPERATING HOURS) CHECKS
Perform the following checks in addition to preoperational checks and one month (200 operating hours)
checks.
Items to be checked
Cra nkc ase – C heck the a ir bre at her f or
•
contamination and clean if necessary.
Engine oil lter – Change.
•
Fuel lter – Clean (gas-powered trucks).
•
Fuel lter – Change (diesel-powered trucks).
•
Carburator – Check linkage for looseness or
•
contamination.
Fuel tank – Drain water (diesel-powered trucks).
•
Cooling water – Change (every 2 years for trucks
•
using LLC).
Fork stopper pins – Check for damage or wear.
•
Distributor – Check for cracked cap (gas-powered
•
trucks)
Spark plug – Adjust the gap (gas-powered
•
trucks).
Spark plug – Clean (gas-powered trucks).
•
Distributor – Check the air gap between rotor and
•
stator and the general condition of rotor (gas-
powered trucks).
Distributor shaft – Lubricate (gas-powered
•
trucks).
S tarter p i n ion g e a r – C h e c k f o r p roper
•
engagement.
Charger – Check for proper operation.
•
Battery – Check the specific gravity of the
•
electrolyte.
Electrical wiring – Check for loose connections.
•
4-37
To Next Page