Why is there no reception on my Uniden Bearcat PC78 Elite Radio?
If you're experiencing no reception on your Uniden Radio, try these steps: First, verify the microphone connection. Next, ensure the CB/WX/PA switch is set to CB. After that, check the VOLUME and SQUELCH settings. Also, check the antenna and its connection. Finally, set the RF GAIN to MAX.
Why does my Uniden Bearcat PC78 Elite have no transmission?
If your Uniden Radio has no transmission, make sure the CB/WX/PA switch is set to CB. Also, check the microphone connection. Finally, check the MIC GAIN and adjust it to MAX.
What to do if my Uniden Bearcat PC78 Elite has poor reception?
If your Uniden Radio has poor reception, try the following: Check the VOLUME and SQUELCH settings. Also, ensure the antenna SWR is normal. Set the RF GAIN to MAX. Finally, check and adjust the DELTA TUNE.
Why is my Uniden Bearcat PC78 Elite transmission so low?
If your Uniden Radio has low transmission, ensure the antenna SWR is normal. Also, check the MIC GAIN and adjust it to MAX.
What to do if my Uniden Bearcat PC78 Elite does not power up?
If your Uniden Radio isn't powering up, here are a few things to check: * Check the ignition key position. * Check the power cord connections. * Check the fuse. * Check the vehicle's electrical system.
General| Type | CB Radio |
|---|---|
| Frequency Range | 26.965 - 27.405 MHz |
| Channels | 40 |
| Modulation | AM |
| Power Output | 4 Watts |
| RF Gain | Yes |
| Instant Channel 9 | Yes |
| SWR Meter | Yes |
| PA Function | Yes |
| Antenna Impedance | 50 Ohms |
| Power Supply | 13.8V DC |
| Microphone | Dynamic |
| Display | LCD |
Discusses the FCC ruling that CB radio operators no longer need a license.
Details how to use the CB radio for emergency communication, especially Channel 9.
Steps for installing the CB radio in a mobile vehicle, including mounting and wiring.
Importance of antenna quality for transmission distance and proper matching.
Advice on grounding and preventing electrolysis for marine installations.
Recommends connecting power to the ignition switch accessory terminal for automatic shut-off.
Explains negative and positive ground systems in vehicles and how to connect the power cords.
To Next Page