To Next Page
G
Gregory RivasAug 19, 2025
Why does my Uniden Bearcat 980 SSB have no transmission?
- SShane GouldAug 20, 2025
If your Uniden Radio has no transmission, set the CB/PA switch to CB, check the microphone connection, and adjust the MIC Gain.
Why does my Uniden Bearcat 980 SSB have no transmission?
If your Uniden Radio has no transmission, set the CB/PA switch to CB, check the microphone connection, and adjust the MIC Gain.
What to do if my Uniden Radio has no reception?
If your Uniden Radio has no reception, check the microphone connection, set the CB/PA switch to CB, and verify the VOLUME and SQUELCH settings. Inspect the antenna and its connection, and adjust the RF Gain.
Why is the reception on my Uniden Radio so poor?
If your Uniden Radio has poor reception, verify the VOLUME and SQUELCH settings. Ensure that the antenna SWR is normal, and adjust the RF Gain.
How to fix low transmission on Uniden Bearcat 980 SSB Radio?
If your Uniden Radio has low transmission, you should adjust the MIC Gain.
Why does my Uniden Bearcat 980 SSB Radio have poor reception?
If your Uniden Radio has poor reception, check the VOLUME and SQUELCH levels. Ensure that the antenna SWR is normal and adjust the RF Gain.
How to fix a Uniden Radio that does not power up?
If your Uniden Radio unit isn't powering up, verify the power cord connections, inspect the fuse, and check the vehicle's electrical system.
What to do if Uniden Bearcat 980 SSB battery check returns FAILLO FAILHI error?
If your Uniden Radio's battery power check returns FAILLO FAILHI or ., ensure your power wires have a solid connection. Verify that your battery is fully charged, as lower voltage can cause this failure. Also, check your alternator.
What to do if Uniden Radio RF power diagnosis check FAIL?
If your Uniden Radio RF power diagnosis check fails, make sure your antenna ground is good, inspect your antenna for any damage, and check the antenna connection on the back of the radio to ensure it's tight.
What to do if Uniden Radio antenna check FAIL?
If your Uniden Radio antenna check fails, ensure your antenna ground is properly connected. Check the antenna for any signs of damage. Have the SWRs checked at a CB shop, as high SWRs can damage the radio.
What to do if Uniden Bearcat 980 SSB Radio does not work as well as previously?
If your Uniden Radio unit isn't working as well as it used to, try turning the power off and then back on. This will reset the channels.
Mandatory safety precautions for radio installation and operation, including antenna placement and regulatory compliance.
Step-by-step guide for initiating emergency broadcasts, primarily using Channel 9.
Adjusts audio level and filters background noise for optimal listening.
Details buttons for Talkback, RF Gain, and their associated status indicators.
Controls microphone sensitivity and enables access to weather channels.
Initial setup for volume, channel selection, noise limitation, and squelch.
Using the weather radio function and setting up weather alert notifications.
Solutions for issues like no power, no reception, and poor transmission.
General| Type | CB Radio |
|---|---|
| Frequency Range | 26.965 MHz to 27.405 MHz |
| Channels | 40 |
| Power Output | 4W AM, 12W SSB |
| Weather Alert | Yes |
| RF Gain | Yes |
| Microphone Connector | 4-Pin |
| Antenna Impedance | 50 ohms |
| Power Supply | 13.8 VDC |
| Modes | AM, SSB |
| Display | LCD |
| Microphone | Dynamic |
