Why MEM/SCAN does not access channels in memory on Uniden Bearcat 980 SSB Radio?
If using MEM/SCAN does not access channels in memory on your Uniden Radio, verify that you have saved channels into the memory.
What to do if my Uniden Radio unit does not power up?
If your Uniden Radio unit does not power up, check the power cord connections, inspect the fuse, and verify the vehicle's electrical system.
What to do if my Uniden Radio battery power check returned FAILLO FAILHI or .?
If the Uniden Radio battery power check returns FAILLO FAILHI, ensure the power wires have a solid connection. Check the battery charge, as it needs to be fully charged; lower voltage will cause a failure. Also, check the alternator.
General| Type | CB Radio |
|---|---|
| Frequency Range | 26.965 MHz to 27.405 MHz |
| Channels | 40 |
| Power Output | 4W AM, 12W SSB |
| Weather Alert | Yes |
| RF Gain | Yes |
| Microphone Connector | 4-Pin |
| Antenna Impedance | 50 ohms |
| Power Supply | 13.8 VDC |
| Modes | AM, SSB |
| Display | LCD |
| Microphone | Dynamic |
Mandatory safety precautions for radio installation and operation, including antenna placement and regulatory compliance.
Step-by-step guide for initiating emergency broadcasts, primarily using Channel 9.
Adjusts audio level and filters background noise for optimal listening.
Details buttons for Talkback, RF Gain, and their associated status indicators.
Controls microphone sensitivity and enables access to weather channels.
Initial setup for volume, channel selection, noise limitation, and squelch.
Using the weather radio function and setting up weather alert notifications.
Solutions for issues like no power, no reception, and poor transmission.
To Next Page