Uniden DECT 1730 Series - Using the Special Features; Multi-Handset Features; Conference Calling; Call Transfer

16
USING THE SPECIAL FEATURES
Multi-Handset Features
Conference Calling
• When an outside call comes in, two handsets can join in a
conference call with the outside caller.
• To join a call that’s already in progress, just press TALK/FLASH or
SPEAKER.
• To leave the conference call, hang up normally; the other handset
remains connected to the call.
To... Press...
transfer a call INTCOM/CLEAR. The phone puts
the call on hold and prompts you to
select the handset you want to page.
When the other handset accepts the
call, you’ll be disconnected (press
TALK /FLASH to rejoin the call).
cancel a transfer TALK /FLASH to return to the call.
accept a transferred call INTCOM/CLEAR to answer the page
and speak to the other handset.
Then, press TALK/FLASH to speak
to the caller.
Call Transfer
#To use the features in this section, you need at least 2 handsets.
• Your base supports a total of 6 cordless handsets.
• You must register accessory handsets to the base before using
them. (Handsets that came packaged with the base are already
registered.)
• Handsets that aren’t registered display a Not Registered message.
For registration instructions, see page 26, or see the accessory
handset manual.
• If a handset was ever registered to a base, you must reset it before
it can register to a new base; see page 26, or see the accessory
handset manual.