23
Using the System While You’re Away from Home
You can dial in to your answering system from any touch-tone phone.
Before you can use this feature, you must program a security code.
Programming a Security Code
1. With the phone in standby, open the menu from any handset.
2. Select Ans. Setup, then select Security Code.
3. Use the number keypad to enter a two-digit security code (00 to 99).
Press MENU/SELECT when you’re finished.
#Remember to make a note of your new security code!
The default security code is 80.
Dialing In to Your System
1. Call your phone number & wait until the system answers. (If the
system is turned off, it answers after 15 rings & sounds a series of
beeps.)
2. During the greeting or beeps, press
“#”
and immediately enter your
security code. If you enter it incorrectly 3 times, the system hangs up
and returns to standby.
3. The system announces the time, the number
of messages in memory, and a help prompt. It beeps to let you know
it’s waiting for a command.
4. When you hear beeping, enter a 2-digit command from the chart.
For example: to Play message, press # and then 2.
#1 Repeat message #5 Stop playback
#2 Play message #6 Turn the system on
#3 Skip message #9 Turn the system off
#4 Delete message #0 Hear help prompts
#If you don’t press any keys for 15 seconds, the phone will hang up and
return to standby.
To Next Page
Loading...
