5
Engine Noise Suppression
The SOLARA has been designed to minimize ignition and alternator
noise. However, in some installations it may be necessary to take
additional steps to help eliminate noise interference. During installation,
try to direct the DC battery wires, the antenna lead, and accessory
cables away from the engine compartment or ignition and alternator
wiring.
If the noise continues, it may be necessary to install a noise suppression
kit. Contact your Uniden dealer for more information.
Installing the SOLARA
After choosing a location, position the radio (with the bracket,
microphone, power cord, antenna cable, and external speaker lead, if
installed) to make sure it fits. Then follow these steps:
1. Using the bracket as a template, mark the holes for the mounting
hardware.
2. Drill the holes and mount the
bracket with hardware
appropriate for the mounting
surface.
Note: This HEXAGON HEAD
BOLT is only for mounting the
bracket with hardware. Do not
use it for installing the radio in
the mounting bracket.
3. Connect the red power lead to
the positive (+) battery terminal
or to an accessory contact in
your vessel’s fuse box.
Note: The power cord is
equipped with a 6-ampere fast
blow fuse to protect your radio.
Use only a 6-ampere
replacement fuse.
To Next Page
Loading...
Need help?
General
