To Next Page
D
Daniel OconnellJul 30, 2025
How to fix a Uniden OCEANUS DSC that won’t power on?
- Jjackie20Jul 30, 2025
If your Uniden Marine Radio won’t power on, the issue is likely due to no or low voltage. Check for proper voltage getting to the set.
How to fix a Uniden OCEANUS DSC that won’t power on?
If your Uniden Marine Radio won’t power on, the issue is likely due to no or low voltage. Check for proper voltage getting to the set.
What to do if my Uniden OCEANUS DSC transmits a click but no audio?
If, when you press the PTT button on your Uniden Marine Radio, the Tx icon comes on and another radio can hear a click but no audio, it indicates a bad mic element. You should send it in for repair.
Why does my Uniden Marine Radio Tx icon come on, another radio can hear a 'click' but no audio is heard?
If, when the PTT is pressed, the Tx icon comes on and another radio can hear a “click” but no audio is heard, it could be due to a bad mic element. In this case, send it in for repair.
What to do if there is noise on my Uniden OCEANUS DSC Marine Radio receiver that the squelch will not eliminate?
If your Uniden Marine Radio receiver has noise that the squelch won't eliminate, it's likely that an external device is generating noise. You can either turn off the device causing the issue or contact the manufacturer regarding FCC part 15 “unintentional radiator”.
Why does my Uniden OCEANUS DSC Marine Radio stop on a channel while scanning?
If your Uniden Marine Radio stops on a particular channel all the time while scanning, it's likely due to a nearby source of noise. Try to eliminate the source of the noise, or delete the channel from the scanner.
What to do if my Uniden Marine Radio won’t power on?
If your Uniden Marine Radio won’t power on, it might be due to no or low voltage. Check for proper voltage getting to the set.
Why does my Uniden OCEANUS DSC stop on a particular channel all the time?
Your Uniden Marine Radio might be stopping on a particular channel repeatedly because an external noise is being generated by some device.
Identifies and explains the front panel controls and indicators of the radio.
Specifies the pin assignments and functions for the ACC connector.
Factors to consider when selecting an optimal location for the radio.
Instructions for turning the radio on/off and how it remembers the last channel.
How to access Channels 16/9 and activate Triple Watch mode for monitoring.
Steps to make an individual DSC call to another vessel.
How to adjust the display contrast level.
Details the specifications for connecting an external GPS via NMEA0183.
Technical details of the radio's transmitter capabilities.
Technical details of the radio's receiver capabilities.
General| DSC | Yes |
|---|---|
| GPS Input | Yes |
| Display Type | LCD |
| S.A.M.E. Weather Alert | Yes |
| GPS Built-in | No |
| Transmitter RF Output Power | 25W / 1W |
