1. Press and hold H/L/MENU for 2 seconds
to enter Menu Operation.
2. Press CH ▼ once to display
SETUP,
and press SELECT.
SETUP has 9 options as follows. To exit, select EXIT.
2-A-1. ALARM SET
This feature allows you to set the alarm.
1. Press SELECT at
SETUP.
ALARM CLOCK appears.
2. Press SELECT.
3. Press CH ▲ or ▼ to select On.
Then, press and hold SELECT.
4. Select the hour using CH ▲ and ▼,
then press SELECT.
5. Select the minute using CH ▲ and ▼,
then press SELECT.
30
2. SETUP
2-A. ALARM CLOCK
This feature is only available when the GPS is connected to the
NMEA0183 Accessory Wires. If it is connected to the GPS, the alarms
are set based on the satellite. You need to set the time previously to
setting the alarm.
UT01910ZZ_0 9/18/03 5:37 PM Page 30
To Next Page
Loading...
Need help?
General
